Aqua-Flash 500

Materials
A composite sheet type waterproofing membrane consisting of 8 mils of high density cross laminated polyethylene bonded to 32 mils of rubberized asphalt for a total thickness of 40 mils. Available in 12", 16", 18", 24" and 36" widths. Standard length is 50 linear feet.

Applications
• Thru-wall flashing
• Concealed flashing
• Foundation sill flashing
• Base flashing
• Spandrel flashing
• Head and sill flashing
• Parapet flashing

Features
A composite flashing which:
• Is self-sealing
• Has excellent puncture resistance
• Is self-healing since the adhesive system will elongate and recover if somewhat damaged
• Needs no reglet when adhering membrane to vertical substrate

AQUA-MASTIC® AND AQUA-PRIMER®
AQUA-MASTIC and AQUA-PRIMER are available in 5 gallon pails.
AQUA-MASTIC is also available in 32 oz. tubes.

Special Requirements
All materials specified shall be delivered to the jobsite in approved manufacturer's sealed containers bearing manufacturer's name and material identification.

Preparation
All masonry and other surfaces receiving flashing should be reasonably smooth, free from loose material and completely dry. There shall be no slopes which would prevent free flow of water to the exterior surface of the wall. All work shall be executed in conformance with acceptable trade practices.

Application Instructions
AQUA-FLASH 500 should be cut into manageable lengths of approximately 8 to 10 feet. Remove the release liner.

Apply AQUA-FLASH 500 membrane starting from the lowest point and work upwards. Once the membrane is in place, use a steel hand roller to secure the flashing firmly in place. All side laps should be a minimum of 2 1/2".

Inside and outside corners must be covered with the two layers of membrane and sealed mastic.

Once installed, no maintenance is required.

NOTE:
• Not to be used for exposed flashing.
• Not to be applied below 25ºF.
• Not to be applied below 40ºF without a primer.
• Not to be used with oil based, wax based or polysulfide sealants or creosote.

Storage
Temperature not to exceed 120ºF or go below 25º F. Protect products from inclement weather or excessive heat.

WIRE-BOND®

Corporate Office
400 Roundtree Rd
P.O. Box 240988
Charlotte, NC 28224
Tel: (704) 525-5554
Toll-Free: (800) 849-MRCA (6722)
Fax: (704) 525-3761
Web site: http://www.wirebond.com

Memphis Plant
2365 Harbor Ave.
Memphis, TN 38113
Tel: (901) 775-9444
Toll-Free: (800) 441-8359
Fax: (901) 775-9449

04082/MAS
BuyLine 0452