Petersen Aluminum Corporation -PAC T-250 Metal Roof Panel

DOWNLOADS

PAC T-250 panels are factory-formed or field-formed to length and field-seamed. The panels have been designed for application over a wide variety of substrates on roof slopes as low as 1/2 : 12. PAC T-250 panels can be produced in 22 and 24 gauge steel or .032 and .040 aluminum.


Category: metal roofing | roof panels | sheet metal roofing...

MasterFormat: Metal Roof Panels | Flashing and Sheet Metal | Sheet Metal Roofing...



Petersen Aluminum Corporation
1005 Tonne Road
Elk Grove Village, IL 60007
Tel: (800) 722-2523
Fax: (800) 722-7150

info@pac-clad.com

https://www.pac-clad.com

Find a rep/distributor

Request More Info

DOWNLOADS

Related Products

Overview


PAC T-250 Metal Roof Panel

PAC T-250 panels are factory-formed or field-formed to length and field-seamed. The panels have been designed for application over a wide variety of substrates on roof slopes as low as 1/2 : 12. PAC T-250 panels can be produced in 22 and 24 gauge steel or .032 and .040 aluminum. The PAC T-250 panel combines structural performance with architectural aesthetics. PAC T-250 panels feature a 2.625” nominal finished panel height from the deck that requires mechanical field seaming after installation. The panels have a continuous and/or intermittent concealed-fastener clip system designed to allow for thermal expansion/contraction. Sealant beads are factory-applied to the seam cover.

Trim
All flashing and trim shall be fabricated by Petersen or a qualified fabricator. Flashing shall be PAC-CLAD aluminum or steel. A 30-year non-prorated finish warranty can be supplied covering finish performance. Vinyl film is recommended on all fabrication applications where extra handling is expected. NOTE: The strippable film must be removed immediately after installation.

Installation
PAC T-250 panels are intended for use in architectural and structural roofing. Substrates may include 5/8” min. plywood, nailboard insulation or equal with an underlayment of ice and water shield applied horizontally from eave to ridge. Other substrates may include metal decking, purlins or rigid insulation in conjunction with bearing plates. Contact Petersen for further assistance with installation details. For coastal applications, aluminum panels along with stainless steel clips must be used to qualify for warranty. Consult a local architect/engineer for compliance with local codes and conditions.

Seaming
PAC T-250 panels require the use of mechanical seamers, which are available along with hand crimpers and other tools through D.I. Roof Seamers, which is the only supplier of this equipment approved by Petersen. For details and rental information, .

Materials
  • 43 stocked colors (24 gauge steel)
    16 stocked colors (22 gauge steel)
  • 36 stocked colors (.032 aluminum)
  • 22 stocked colors (.040 aluminum)
  • Panels available in Galvalume Plus
Features
  • Standard is smooth panel
  • Maximum factory-produced panel length is 54 ft. (check w/factory for longer lengths)
  • Architectural/structural panel
  • Factory-applied sealant in seam cover
  • Continuous interlock
  • 30-year non-prorated finish warranty
  • Weathertightness warranty available


See More


Specifications

Illustrations
PAC T-250 Smooth PanelPAC T-250 StriationsPAC T-250 Pencil Ribs