RMX® Medium-Duty Commercial Door OperatorThe UL 325 2010 certified RMX® medium-duty commercial operator is designed for quicker installation and hassle-free operation. The RMX® offers convenient features and technical innovations found nowhere else in a medium-duty operator.
Features
Motor
Single-phase voltages of 115 Volts AC and 230 Volts AC ½ horsepower
Direct Coupling
Provides fast, easy installation with fewer parts and better structural support
Display
16-character LCD display provides easy-to-read set-up and diagnostics with backlight for low-light conditions
Cycle Counter
Displays the total cycles logged over the operator’s lifetime, to support warranty and service functions
Adjustable Shaft
Output shaft can be moved from one side to the other providing flexible installation options
Independent Timers
Automatic maximum run timer stops the close function if preset run time is exceeded, allowing for inspection
Control system
On-board Open, Close and Stop buttons make set up and testing simple, saving time during installation
Control buttons
Call Mode/Run Mode
Backlight
Scroll Up/Down
Set/Clear
Automatic tensioning belt
No adjustment is needed, belt automatically adjusts itself to the correct tension
Exterior radio hookups
For fast, simple RF connectivity to enable remote door operation
Automatic set-up boards with socket lock protection
Prevents accidental wiring errors through “plug and play” technology
Options
RMX® Trolley
For use on standard lift doors up to 14 feet high and 620 lbs
RMX® Jackshaft with and without Hoist – Sectional Door
For use on vertical lift, lift clearance sectional door up to 16 feet high and 620 lbs
RMX® Jackshaft with and without Hoist – Rolling Service Doors and Grilles
For use with rolling steel doors or grilles up to 16 feet high and 580 lbs in weight
Optional Accessories
Radio Receiver
External terminals allow the connection of an optional external 3-wire receiver
Modules
Auxiliary Output Module - this plug-in module will provide several auxiliary sets of dry contacts that are microprocessor controlled. Outputs can be configured using the on-board keypad.
To maintain compliance when using a sensing edge as a primary safety device with our X-Series commercial operators labeled UL 325 2010, you must use one of the following modules:
Timer to Close Module - provides auxiliary control inputs, auxiliary safety inputs, auxiliary timer hold input, and an automatic door closing feature with a user-selectable time-delay. Safety inputs can be enabled or disabled using the on-board keypad. A sensing device must be used with this module.
Monitored Edge Interface Module – provides an interface between two-wire monitored sensing edges and our X-Series operators. This module allows for the connection of a two-wire monitored sensing edge to be connected to the ODC STB terminals. Compatible for use on Miller Edge electronic two-wire monitored edge models ME, MT and MU.
Sensing Devices
Bottom Sensing Edge - stop and reverses the door upon contact with an obstruction.
Safe-T-Beam® - senses an obstruction and signals the operator to stop or reverse the door.
Overhead Door Corp.
2501 South State Highway 121,Suite 200
Lewisville, TX 75067
Tel: (800) 275-3290
Fax: (972) 906-1499
E-mail: sales@overheaddoor.com
Web site: http://www.overheaddoor.com
|