Sweets

Lyon^® ExchangeMaster^® Lockers

A. 6-COMPARTMENT LOCKERS
Patron door opening 6-1/2"w 38-3/4"h. Inside: 7"w x 41-1/2"h. Overall: 26"w x 21"d x 84"h.

B. 8-COMPARTMENT LOCKERS
Patron door opening: 4-13/16"w x 38-3/4"h. Inside: 5"w x 21"d x 41-1/2"h. Overall: 26"w x 21"d x 84"h.

C. WIDE BODY 8-COMPARTMENT LOCKERS
Patron door opening: 6-1/2"w x 38-3/4"h. Inside: 7"w x 21"d x 41-1/2"h. Overall: 32-9/16"w x 21"d x 84 h.

D. 9-COMPARTMENT LOCKER
Patron door opening:18-1/8" x 8-3/4"h. Inside: 23-7/8"w x 15"d x 8-3/4"h. Overall: 24"w x 15"d x 84"h.

Material – Prime, high-grade Class I mild-annealed, cold-rolled steel free from surface imperfections.

Door Frame Assembly – 16 gauge formed-steel channels. Vertical members have an additional flange to form continuous door strike. Corners are lapped and welded into a rigid assembly. In addition, bottom cross members have tang at each end that engage the vertical members to prevent twisting out of alignment. Top and bottom cross members provide support for front edge of locker top and bottom. All left-hand members have three 14 gauge jambs welded to engage locking device. Jamb design shall prevent freeing of locking device by prying. Each jamb shall have safety reverse nose to eliminate hazard of sharp, pointed edges protruding into the locker. Each jamb has a soft-rubber silencer secured through jamb and frame member.

Hinges – 2" high, .050" steel, five knuckle, full-loop forming double thickness on each leaf. Hinge pin is spun over at ends to prevent removal. Hinges are set in slots in right-hand frame members and projection-welded. All ExchangeMaster® lockers have four hinges.

Anchoring – To prevent tipping or injury, Lyon strongly recommends that lockers be floor and/or wall anchored.

Master-Door Assembly – 16 gauge formed-steel channels. Vertical members have an additional flange to form continuous door strike. Locking device consists of 22 gauge galvanized steel lock bar channel enclosed on three sides by, and operates within, channel format of the left-hand master door member. Locking device prelocks so mechanism can be locked in open position – locking automatically when closed. Lock bar is controlled by a grooved-key lock, built into left-hand master door member. Locking device and master key are interchangeable on all ExchangeMaster® lockers. Lock to be held in place by a spring clip for easy removal and easy access to lock bar.

Compartment Doors – 20 gauge steel formed at approximately 90° angle on all four sides. Six- and 8-compartment doors attached with two Phillips head shoulder screws and "kep" self-locking nuts. Nine-, 10- and 16- compartment doors attached with two #10 special head screws and hex nuts. Each compartment door is fitted with a grooved-key lock with two keys each. Optional padlock attachments, built-in combination locks and turn knob handles are available. Six- and 8- compartment doors have three louvers near top and bottom of each door. Nine-, 10- and 16- compartment doors have on louver at center of each door. Backs of all units are perforated for additional ventilation.

POP-RIVETED, FULLY ASSEMBLED

SHIPPED READY TO USE!

NOTE: In the interest of safety, Lyon strongly recommends that lockers be floor and/or wall anchored.